Keyless Entry Transmitter Does Not Operate Trunk Lid Release
- Backprobe with test light between remote keyless entry module connector C2 terminal "B" (Black wire-Sedan, Brown wire-Wagon). Observe test light and operate keyless entry transmitter trunk lid release button.
- If test light does not flash on once, check for poor connection. If connection is okay, replace remote keyless entry module. If test light does flash on once, check Black or Brown wire for an open circuit.
KEYLESS ENTRY COMPONENT LOCATION
| Component | Location | |
|---|---|---|
| "A" Body | ||
| Door Lock Relay Assembly | On Right Shroud | |
| Fuse Block | Behind Right Side Of Instrument Panel | |
| Programming Connector | Rear Of Vehicle, Near Base Of Left Tailgate Pillar | |
| Release Relay | Behind Right Side Of Instrument Panel, Above Fuse Block | |
| Release Solenoid | On Luggage Compartment Lid, Near Lock | |
| Remote Keyless Entry Module | Left Center Of Luggage Compartment, Near Wheelhouse | |
| "W" Body | ||
| Fuse Block | On Right Side Of Instrument Panel, In Front Door Opening | |
| Keyless Entry Receiver | Right Side Of Rear Shelf | |
| Keyless Programming Connector | Right Side Of Trunk, Above Wheelhouse | |
| Power Door Lock Relay | On Left Shroud, Above Center Access Hole | |
| Transaxle Range Switch | Left Of Engine, On Transaxle | |
| Underhood Electrical Center | Right Side Of Engine Compartment, Front Of Strut Tower | |