FixVault
Home › Buick › 1994 › Park Avenue Base › Repair and Diagnosis (Single Page) › Accessories & Equipment › Anti-Theft Systems › Keyless Entry System - Remote › Programming › Transmitter Programming

Transmitter Programming

NOTE: Following procedure must be performed when replacing RAC module or either transmitter.
  1. Turn ignition switch to OFF position. Use a fused jumper wire and connect Data Link Connector (DLC) terminal "A" to terminal "G". Door locks should lock and unlock.
  2. Press UNLOCK button on one transmitter. Door locks should lock and unlock. Repeat this step if programming another transmitter. Disconnect jumper wire from DLC.
About FixVault