Section 16 (Engine Controls - Tests W/O Codes - Gasoline): Introduction

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 1994 GMC Vandura Special, 1994 GMC Vandura, 1994 GMC Rally Camper Special, 1994 GMC Rally, and 1994 GMC Forward Control. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: These models may use Electronic Control Modules (ECM), Powertrain Control Module (PCM) or Vehicle Control Module (VCM). PCM will be used in this article to describe all control modules.

Before diagnosing symptoms or intermittent faults, perform steps in BASIC TESTING - GASOLINE article and appropriate TESTS W/CODES article in the ENGINE PERFORMANCE section below. Use this article to diagnose driveability problems if a hard fault code is not present or if vehicle is not equipped with a self-diagnostic system.

Symptom checks are intended to direct the technician to malfunctioning component(s) for further diagnosis. A symptom should lead to either specific component or system testing or an adjustment specification. Use intermittent test procedures to locate driveability problems which DO NOT occur when the vehicle is being tested.

NOTE: For specific testing procedures, see appropriate SYSTEM/COMPONENT TESTS - GASOLINE article. For specifications, see ADJUSTMENTS - GASOLINE or SPECIFICATIONS - GASOLINE article in the ENGINE PERFORMANCE section.

NOTE: SERVICE ENGINE SOON light, located on instrument cluster, is also referred to as the Malfunction Indicator Light (MIL).