Section 45 (Memory System): Programming: Personalization

WARNING: This page is about a different car, the 1998 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.

When remote keyless entry (RKE) transmitter is used to unlock doors, remote function actuator (RFA) communicates unlock command and which driver performed command to memory seat/mirror module. Each RKE transmitter is programmed with one of four personalized recall options when RFA receives unlock message:

Mode 0: Memory seat/mirror module sounds single chime and driver's seat will not move.
Mode 1: Memory seat/mirror module sounds single chime and driver's seat and both mirrors will move to position stored for DRIVER-1.
Mode 2: Memory seat/mirror module sounds single chime and driver's seat and both mirrors will move to position stored for DRIVER-2.
Mode 3: Memory seat/mirror module sounds single chime and driver's seat will move to easy exit position (fully back and down).

To program RKE transmitter for specific mode, perform following steps;

Mode 0: Press MEMORY SET button on left seat switch and within 5 seconds press UNLOCK button on RKE transmitter.
Mode 1: Perform memory set function for DRIVER-1 and then within 5 seconds press UNLOCK button on RKE transmitter.
Mode 2: Perform memory set function for DRIVER-2 and then within 5 seconds press UNLOCK button on RKE transmitter.
Mode 3: Perform an easy exit function and then within 5 seconds press UNLOCK button on RKE transmitter or Press UNLOCK button on RKE transmitter and then within 5 seconds, perform easy exit function.