Installation Procedure

WARNING: This page is about a different car, the 2005 Buick LeSabre. However, it is still accessible from the selected car via links, so may be relevant.

Install the CMP sensor to the engine front cover.

Fig 1: Disconnecting/Reconnecting Electrical Connector To CMP Sensor

Courtesy of GENERAL MOTORS CORP.

Install the camshaft position sensor retaining bolt.
Tighten: Tighten the bolt to 10 N.m (89 lb in).
Connect the electrical connector (2) to the camshaft position sensor (1).
Install the drive belt. Refer to Drive Belt Replacement (L36) in Engine Mechanical.
Install the coolant recovery reservoir. Refer to Coolant Recovery Reservoir Replacement in Engine Cooling.