FixVault
Home › Buick › 2001 › LeSabre Custom, 4T65E/MN3 › Repair and Diagnosis (Single Page) › Accessories & Equipment › Heated Glass/Defoggers › Rear Window Defogger & Mirror Defogger › Programming › Rear Integration Module Set Up

Rear Integration Module Set Up

NOTE: This procedure is used after replacing Rear Integration Module (RIM). Before replacing RIM, record personalization settings to transfer to new module (if available). See REAR INTEGRATION MODULE under OPERATION in appropriate BODY CONTROL MODULES article.
  1. Ensure scan tool has been updated with latest software version.
  2. Connect scan tool to DLC. DLC is located on lower left side of instrument panel.
  3. Turn ignition switch to RUN position.
  4. Under CHASSIS MAIN MENU, select REAR INTEGRATION MODULE.
  5. Under REAR INTEGRATION MODULE MAIN MENU, select RECALIBRATION.
  6. Follow scan tool instructions to recalibrate automatic level control.
  7. Perform vehicle personalization to reset owner's desired personalization settings. See VEHICLE PERSONALIZATION and PROGRAMMING PERSONALIZATION FEATURES ON VEHICLES WITHOUT DRIVER INFORMATION CENTER, PROGRAMMING PERSONALIZATION FEATURES WITH DRIVER INFORMATION CENTER, or PROGRAMMING PERSONALIZATION FEATURES WITH SCAN TOOL under PROGRAMMING in appropriate BODY CONTROL MODULES article.
About FixVault