FixVault
Home › Buick › 2002 › Century Custom › Repair and Diagnosis › Steering › Power Steering System › Repair Instructions › Power Steering Cooler Pipe/Hose Replacement › Installation Procedure

Installation Procedure

  1. Install the cooler pipe/hose to the vehicle.
  2. Install the cooler pipe/hose to the steering gear.

    Tighten: 

    Tighten the fitting to 27 N.m (20 ft lbs) 

  3. Install the wiring harness clip to the cooler pipe/hose.
  4. Install the cooler pipe/hose to the clips on the steering gear.
    Fig 1: Cooler Pipe/Hose To Clips
    G01720122Courtesy of GENERAL MOTORS CORP.
  5. Install the cooler pipe/hose to the retaining clip on the frame.
  6. Install the cooler pipe/hose retaining bolt to the frame.

    Tighten: 

    Tighten the bolt to 10 N.m (89 in lbs) 

  7. Install the return hose to the cooler pipe/hose. Refer to Power Steering Return Hose Replacement (3.1L)  or Power Steering Return Hose Replacement (3.8L)  .
  8. Lower the vehicle.
  9. Fill the power steering system. Refer to Checking and Adding Power Steering Fluid .
  10. Bleed the power steering system. Refer to Bleeding the Power Steering System .
  11. Inspect the power steering system for leaks. Refer to Power Steering Fluid Leaks .
About FixVault