Reverse Servo: Removal
- On models with 3.4L engine, remove the throttle body air inlet duct. On models with 3.8L engine, remove air cleaner assembly. On all models, remove the shift cable lever from the manual shaft. See SHIFT CABLE
.
- Depress the reverse servo cover. See Fig 1
. Remove the snap ring. See Fig 2
. Pull the O-ring seal out through the slot in the case. Use side cutting pliers in order to cut the servo cover O-ring seal.
- Depress the reverse servo cover, grasp one end of the cut seal and pull the seal out of the servo cover.
- Remove the reverse servo cover. Remove the servo assembly. Remove the servo spring.
Courtesy of GENERAL MOTORS CORP.
Courtesy of GENERAL MOTORS CORP.