Park Lock Cable (Console Shift - Intrigue): Installation

1. Ensure the cable lock button is in the UP position.
2. Ensure the shift lever is in the Park position.
3. Install the park/lock cable.
4. Snap the cable connector into the shifter base.
5. Install the cable retainer to the park/lock cable at the shift control. See Fig 1 .
6. Ensure the ignition key is in the RUN position.
7. Snap the cable into the inhibitor housing.
   NOTE: Ensure the ignition key is in the LOCK position. Do not attempt to insert the cable with the key in any other position.
8. Turn the ignition key to the LOCK position.
9. Snap the cable end onto the shifter park lock lever pin.
10. Push the cable connector nose forward in order to remove the slack.
11. Snap the cable connector lock button down using no load applied to the connector nose.
12. Inspect the functional operation of the park/lock cable. See PARK LOCK CABLE  under ADJUSTMENTS.
13. Install the knee bolster. See KNEE BOLSTER  .
14. Install the front floor console. See CONSOLE (INTRIGUE)  .
15. Connect the negative battery cable.

Fig 1: Removing & Installing Park Lock Cable Retainer

Courtesy of GENERAL MOTORS CORP.