FixVault
Home › Buick › 2002 › LeSabre Custom, 4T65E/MN3 › Repair and Diagnosis › Suspension › Electronic Suspension System - Automatic Level Control › Diagnostic Information & Procedures › Scan Tool Data Definitions

Scan Tool Data Definitions

  1. Accum Fault- Compressor

    Defined period of time the compressor is active with out an exhaust cycle.

  2. ALC Compressor Active

    Indicates when the compressor is running.

  3. ALC Exhaust Solenoid Active

    Indicates when the exhaust solenoid is on.

  4. ALC Relearn

    This procedure reprograms the RIM with the ride height specification, per the suspension option.

  5. Battery Low-Compressor

    This indicates when there is low voltage at compressor.

  6. Calibration I.D.

    This number designates the modules calibration.

  7. Exhaust

    Defined period of time that the exhaust is active with out a compressor cycle.

  8. Filtered Position Valve

    As the vehicle operates the suspension position sensor is monitored, and the information is filtered, to the RIM so it can adjust the suspension.

  9. Leveling Sensor Feed

    Voltage feed to the suspension position sensor.

  10. Progress Fault- Compressor

    Defined period of time the that the compressor is active, and a change is not detected by the sensor.

  11. Progress Fault- Exhaust

    Defined period of time that the exhaust is active and no change is detected at the sensor.

  12. Prom I.D.

    The modules internal "PROM" identifier.

  13. Suspension Position Sensor

    Indicates the sensor signal voltage to the control module.

  14. Trim Value

    A value programed in the RIM.
About FixVault