FixVault
Home › Buick › 2002 › Park Avenue Base › Repair and Diagnosis › Suspension › Electronic Suspension System - Automatic Level Control › Repair Instructions › Automatic Level Control Air Compressor Head Replacement › Assembly Procedure

Assembly Procedure

  1. Install the new gasket on the air compressor assembly.
  2. Install the air compressor head on the air compressor assembly with three bolts. Tighten three bolts to 6 N.m (53 in lbs).
  3. Connect the air hose to the air compressor head.
  4. Install the two wire terminals in the air compressor connector.
  5. Install the wrap around four wires and secure with two harness ties.
  6. Install four wires in the harness tie and install the harness tie on the air compressor head with the bolt. Tighten the bolt to 3 N.m (26 in lbs).
  7. Install the air dryer. Refer to Automatic Level Control Air Dryer Replacement .
  8. Install the heat shield and the harness tie on the air compressor bracket with three screws. Tighten three screws to 4 N.m (35 in lbs).
  9. Connect the air compressor connector to the connector anchor.
  10. Install the air compressor on the vehicle. Refer to Air Compressor Replacement .
About FixVault