FixVault
Home › Buick › 2003 › Century Base › Repair and Diagnosis › External Pages › Different car › Section 435 (Supplemental Inflatable Restraint System) › Repair Instructions › Inflatable Restraint Side Impact Module Replacement - LH › Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Buick Regal and 2004 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Refer to SIR Caution in Cautions and Notices.
    CAUTION: Refer to SIR Inflator Module Handling and Storage Caution in Cautions and Notices.
  1. Disable the SIR system. Refer to SIR Disabling and Enabling Zone 7 .
    2. CAUTION: Following the deployment of a side impact air bag, replace the following parts:
    • The seat back trim
    • The seat back pad
    • The seat back frame

    Failure to do so may cause future personal injury.
  2. If the air bag has been deployed, replace the seat back trim, the seat back pad, and the seat back frame. Refer to Seat Back Frame Replacement - Front in Seats.
  3. Remove the seat back cover, as needed. The head restraint does not need to be removed. Refer to Seat Back Cover Replacement - Front in Seats.
    4. Fig 1: Locating Inflator Module Components
    GM307452Courtesy of GENERAL MOTORS CORP.
  4. Remove the fasteners (2) from the inflator module (1).
  5. Note the routing of the inflator module wiring harness (4) and of the retaining clip attachments within the driver seat.
  6. Remove the retaining clips on the inflator module wiring harness from the driver seat frame.
  7. Gently pull the inflator module wiring harness (4) up into the seat back while guiding the harness through the wire triangle of the seat frame.
  8. Remove the inflator module (1) from the driver seat back frame.
  9. Fully deploy the module before disposal. If the module was replaced under warranty, fully deploy and dispose of the module after the required retention period. Refer to Inflator Module Handling and Scrapping .
About FixVault