FixVault
Home › Buick › 2003 › Century Base › Repair and Diagnosis › External Pages › Different car › Section 435 (Supplemental Inflatable Restraint System) › Repair Instructions › Inflatable Restraint Side Impact Sensor Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Buick Regal and 2004 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove any dirt, grease, or other impurities from the mounting surface.
    2. Fig 1: Locating Side Impact Sensor
    GM300150Courtesy of GENERAL MOTORS CORP.
  2. Connect the side impact sensor connector.
  3. Install the CPA to the side impact sensor connector.
  4. Install the side impact sensor (1) to the center pillar (3).
  5. Point the arrow on the sensor toward the front of the vehicle.
    6. NOTE: Refer to Fastener Notice in Cautions and Notices.
  6. Install the fasteners (2) to the side impact sensor (1) and tighten using hand pressure.

    Tighten:  Tighten the fasteners to 10 N.m (89 lb in).

  7. Install the center pillar lower trim. Refer to Trim Panel Replacement - Lower Center Pillar in Interior Trim.
  8. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 9 .
About FixVault