FixVault
Home › Buick › 2003 › Century Base › Repair and Diagnosis › External Pages › Different car › Section 437 (Seat System) › Repair Instructions › Heated Seat Control Module Replacement - Front › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Buick Regal and 2004 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Heated Seat Control Module & Electrical Harness Connector
    GM816209Courtesy of GENERAL MOTORS CORP.
  1. Position the heater module to the front seat.
  2. Connect the electrical harness connector (1) to the heater module (2).
    3. Fig 2: Heated Seat Control Module & Retaining Pin
    GM909553Courtesy of GENERAL MOTORS CORP.
  3. Position the module (1) on the frame and push in to attach the retaining pin (2)
  4. Lower the seat.
  5. Connect the seat electrical harness connector.
    6. NOTE: Refer to Fastener Notice in Cautions and Notices.
  6. Install the bolts that secure the front bucket seat adjuster to the floor pan.

    Tighten:  Tighten the bolts to 42 N.m (31 lb ft).

  7. Reposition the front seat to the original position.
About FixVault