FixVault
Home › Buick › 2003 › Century Base › Repair and Diagnosis › External Pages › Different car › Section 444 (Body Front End) › Repair Instructions › Hood Latch Support Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Buick Regal and 2004 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Hood Latch Support Bracket Nut
    GM456736Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the hood latch support to the vehicle.
  2. Install the bolts to the hood latch support at the upper tie bar.

    Tighten:  Tighten the bolts to 25 N.m (18 lb ft).

    3. Fig 2: Hood Latch Support Bracket Bolts
    GM456737Courtesy of GENERAL MOTORS CORP.
  3. Install the nut to the hood latch support at the lower tie bar.

    Tighten:  Tighten the nut to 10 N.m (18 lb in).

  4. Install the front bumper fascia bracket to the hood latch support. Refer to Fascia Bracket Replacement - Front Bumper in Bumpers.
  5. Install the hood latch to the hood latch support bracket. Refer to Hood Latch Replacement .
About FixVault