FixVault
Home › Buick › 2004 › Century Base › Repair and Diagnosis › Brakes › Antilock Brake System And Traction Control System › Repair Instructions › Brake Pressure Modulator Valve (BPMV) Bracket Replacement › Installation Procedure

Installation Procedure

    Fig 1: BPMV Mounting Bracket & EBCM Assembly
    GM394422Courtesy of GENERAL MOTORS CORP.
  1. Install the BPMV and EBCM assembly (2) to the BPMV mounting bracket (4).
  2. Install the BPMV bracket (4) to the strut tower.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the 1 bolt and 3 nuts that attach the BPMV mounting bracket (4) to the strut tower.

    Tighten: 

    • Tighten the lower 2 BPMV mounting bracket nuts (3) and bolt to 10 N.m (89 lb in).
    • Tighten the top nut (1) for BPMV mounting bracket (4) to strut tower to 3 N.m (27 lb in).

  4. Reconnect the ground strap between the EBCM assembly and the chassis.
  5. Turn the ignition switch to the RUN position, engine off.
  6. Perform the Diagnostic System Check - ABS .
About FixVault