FixVault
Home › Buick › 2004 › Century Custom › Repair and Diagnosis › Transmission › Automatic Trans › Automatic Transaxle - 4T65-E (Introduction) › Repair Instructions › Park Lock Cable Replacement › Installation Procedure

Installation Procedure

  1. Ensure the cable lock button is in the UP position.
  2. Ensure the shift lever is in the PARK position.
  3. Install the park/lock cable.
  4. Snap the cable connector into the shifter base.
    5. Fig 1: View Of Park/Lock Cable & Retainer
    GM161186Courtesy of GENERAL MOTORS CORP.
  5. Install the cable retainer to the park/lock cable at the shift control.
  6. Ensure that the ignition key is in the RUN position.
  7. Snap the cable into the inhibitor housing.
    8. IMPORTANT: Ensure that the ignition key is in the LOCK position. Do NOT attempt to insert the cable with the key in any other position.
  8. Turn the ignition key to the LOCK position.
  9. Snap the cable end onto the shifter park lock lever pin.
  10. Push the cable connector nose forward in order to remove the slack.
  11. Snap the cable connector lock button down using no load applied to the connector nose.
  12. Inspect the functional operation of the park/lock cable. Refer to Park Lock Cable Adjustment .
  13. Install the knee bolster. Refer to Knee Bolster Replacement in Instrument Panel, Gages and Console.
  14. Install the front floor console. Refer to Console Replacement - Front Floor in Instrument Panel, Gages and Console.
  15. Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.
About FixVault