FixVault
Home › Buick › 2004 › LeSabre Custom, 4T65E/MN3 › Repair and Diagnosis › Engine Performance › System › Engine Controls (Introduction) - 3.8L (L36 And L67) › Repair Instructions › Accelerator Controls Cable Bracket Replacement › Removal Procedure

Removal Procedure

  1. Remove the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement (L36) in Engine Mechanical.
    2. Fig 1: Cruise Control Cable
    GM179339Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the cruise control cable (1) from the throttle lever.
  3. Disconnect the cruise control cable (1) from the bracket (2).
    4. Fig 2: Accelerator Cable
    GM179346Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the accelerator cable (2) from the throttle lever.
  5. Disconnect the accelerator cable (2) from the bracket (1).
    6. Fig 3: Electrical Wiring Harness To The Accelerator Controls Bracket
    GM179374Courtesy of GENERAL MOTORS CORP.
  6. Remove the wiring harness clip (1) from bracket (3) if necessary (VIN K only).
    7. Fig 4: Accelerator Controls Cable Bracket
    GM12246Courtesy of GENERAL MOTORS CORP.
  7. Remove the two bolts from the bracket.
About FixVault