FixVault
Home › Buick › 2004 › Regal LS › Repair and Diagnosis › Engine Performance › System › Engine Controls 3.8L (Introduction, Service & Replacement) › Repair Instructions › Air Cleaner Intake Duct Replacement › Installation Procedure

Installation Procedure

    Fig 1: Locating Intake Air Temperature Sensor Components
    GM760425Courtesy of GENERAL MOTORS CORP.
  1. Install the air cleaner intake duct to the throttle body.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the air cleaner intake duct to the air cleaner cover.

    Tighten:  Tighten the air cleaner duct clamp to 2 N.m (18 lb in).

  3. Install the IAT sensor.
  4. Connect the IAT sensor electrical connector (3).
About FixVault