FixVault
Home › Buick › 2004 › Regal LS › Repair and Diagnosis › Engine Performance › System › Engine Controls 3.8L (Introduction, Service & Replacement) › Repair Instructions › Fuel Tank Pressure Sensor Replacement › Removal Procedure

Removal Procedure

    Fig 1: View Of Fuel Sender Access Panel
    GM65739Courtesy of GENERAL MOTORS CORP.
  1. Remove the rear compartment trim panel. Refer to Compartment Trim Panel Replacement - Rear in Body Rear End.
  2. Remove the retaining nuts from the fuel sender access panel.
  3. Remove the fuel sender access panel.
    4. Fig 2: Fuel Pump & Sender Assembly Component View
    GM50636Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the fuel tank pressure sensor electrical connector.
  5. Remove the fuel tank pressure sensor (7) from the fuel sender assembly.
About FixVault