FixVault
Home › Buick › 2005 › Allure CX › Repair and Diagnosis › Engine Performance › System › Engine Control System - 3.8L - Introduction (2 Of 2) › Repair Instructions › Fuel Tank Pressure Sensor Replacement › Removal Procedure

Removal Procedure

    Fig 1: Locating Fuel Sender Access Panel
    GM65739Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.
  2. Remove the fuel tank assembly. Refer to Fuel Tank Replacement .
    3. Fig 2: Fuel Pump & Sender Assembly Component View
    GM50636Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the fuel tank pressure sensor electrical connector.
  4. Remove the fuel tank pressure sensor (7) from the fuel sender assembly (1).
About FixVault