Removal Procedure

WARNING: This page is about a different car, the 2005 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.

Remove the trim panel. Refer to Trim Panel Replacement - Side Rear Door .
Remove the water deflector. Refer to Water Deflector Replacement - Rear Door .
Position the window in a position that allows access to the window clamp bolts.

Fig 1: Rear Power Window Module

Courtesy of GENERAL MOTORS CORP.

Disconnect the window motor electrical connector.
Position the window in the full up position and tape in place.
Slightly loosen the fasteners on the window clamps.
Remove the 5 fasteners (1) retaining the window module to the door.
Remove the window module from the door.