FixVault
Home › Buick › 2005 › Century Base › Repair and Diagnosis › External Pages › Different car › Section 19 (Engine Controls 3.1L (Introduction, Service & Replacement)) › Repair Instructions › Air Cleaner Intake Duct Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Air Cleaner Intake Duct Components
    GM811623Courtesy of GENERAL MOTORS CORP.
  1. If removed, install the IAT sensor (1).
  2. Install the air cleaner intake duct to the MAF sensor (7).
  3. Install the air cleaner intake duct to the throttle body and the air cleaner assembly.
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the air cleaner intake duct clamps (2,6).

    Tighten:  Tighten the clamps to 2 N.m (18 lb in).

  5. Connect the MAF sensor electrical connector (5).
  6. Connect the IAT sensor electrical connector (3).
  7. Install the PCV tube (4) to the air cleaner intake duct.
About FixVault