FixVault
Home › Buick › 2005 › Century Base › Repair and Diagnosis › External Pages › Different car › Section 19 (Engine Controls 3.1L (Introduction, Service & Replacement)) › Repair Instructions › Fuel Tank Pressure Sensor Replacement › Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Fuel Sender Access Panel
    GM65739Courtesy of GENERAL MOTORS CORP.
  1. Remove the rear compartment trim panel. Refer to Compartment Trim Panel Replacement - Rear in Body Rear End.
  2. Remove the fuel sender access panel nuts.
  3. Remove the fuel sender access panel.
    4. Fig 2: Fuel Pump & Sender Assembly Component View
    GM50636Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the electrical connector from the fuel tank pressure sensor.
  5. Remove the fuel tank pressure sensor (7) from the fuel sender assembly.
About FixVault