FixVault
Home › Buick › 2005 › Century Base › Repair and Diagnosis › External Pages › Different car › Section 23 (Supplemental Inflatable Restraint System) › Repair Instructions › Inflatable Restraint Side Impact Sensor Replacement › Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Buick Regal and 2004 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Side Impact Sensor
    GM300150Courtesy of GENERAL MOTORS CORP.
    CAUTION: Do not strike or jolt the inflatable restraint side impact sensor (SIS). Before applying power to the SIS make sure that it is securely fastened. Failure to observe the correct installation procedures could cause SIR deployment, personal injury, or unnecessary SIR system repairs.
    CAUTION: Refer to SIR Caution in Cautions and Notices.
  1. Disable the SIR system. Refer to SIR Disabling and Enabling Zone 9 .
  2. Remove the center pillar lower trim. Refer to Trim Panel Replacement - Lower Center Pillar in Interior Trim.
  3. Loosen the 2 fasteners (2) on the inflatable restraint side impact sensor (1).
  4. Remove the inflatable restraint side impact sensor (1) from the center pillar (3).
  5. Remove the connector position assurance (CPA) from the side impact sensor connector.
  6. Disconnect the side impact sensor connector.
About FixVault