FixVault
Home › Buick › 2005 › Century Base › Repair and Diagnosis › External Pages › Different car › Section 30 (HVAC Systems - Automatic) › Repair Instructions › Vacuum Control Assembly Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Buick Regal and 2004 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Vacuum Control Assembly
    GM295343Courtesy of GENERAL MOTORS CORP.
  1. Align the tab to the slot in the HVAC module case, then push up to seat the vacuum control assembly.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the mounting screws to the vacuum control assembly.

    Tighten:  Tighten the screws to 1.5 N.m (13 lb in).

    3. Fig 2: View Of Vacuum Harness Connector For Vacuum Control Assembly
    GM295340Courtesy of GENERAL MOTORS CORP.
  3. Connect the vacuum harness connector to the vacuum control assembly.
    4. Fig 3: View Of Electrical Connector For Vacuum Control Assembly
    GM295337Courtesy of GENERAL MOTORS CORP.
  4. Connect the electrical connector to the vacuum control assembly.
  5. Install the right side instrument panel insulator. Refer to Closeout/Insulator Panel Replacement - Right in Instrument Panel, Gages and Console.
About FixVault