FixVault
Home › Buick › 2005 › Century Base › Repair and Diagnosis › External Pages › Different car › Section 32 (Body Front End) › Repair Instructions › Fender Replacement - Front › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Buick Regal and 2004 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the fender to the vehicle.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the bolts to the fender at the front compartment side rail.

    Tighten:  Tighten the bolts to 6 N.m (53 lb in).

    3. Fig 1: Fender To Front Compartment Side Rail Bolts
    GM363624Courtesy of GENERAL MOTORS CORP.
  3. Install the bolts to the fender at the rocker panel.

    Tighten:  Tighten the bolts to 6 N.m (53 lb in).

    4. Fig 2: Fender To Rocker Panel Bolts
    GM363613Courtesy of GENERAL MOTORS CORP.
  4. Install the bolts to the fender at the door hinge pillar.

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

    5. Fig 3: Fender To Door Hinge Pillar Bolt
    GM363642Courtesy of GENERAL MOTORS CORP.
  5. Install the bolts to the fender at the lower engine compartment side rail.

    Tighten:  Tighten the bolts to 5 N.m (44 lb in).

  6. Install the washer solvent container (right fender). Refer to Washer Solvent Container Replacement in Wipers/Washer Systems.
  7. Install the front fender liner. Refer to Front Fender Liner Replacement .
  8. Install the hood hinge. Refer to Hood Hinge Replacement .
  9. Install the hood. Refer to Hood Replacement .
  10. Install the rocker finish panel. Refer to Molding Replacement - Rocker Panel .
  11. Install the headlamp. Refer to Headlamp Assembly or Headlamp Bulb and/or Cornering, Sidemarker, Park, Turn Signal Bulb Replacement in Lighting Systems.
  12. Install the body side molding, if required. Refer to Molding Replacement - Body Side in Exterior Trim.
About FixVault