FixVault
Home › Buick › 2005 › LaCrosse CX › Repair and Diagnosis › Transmission › Automatic Trans › Automatic Transaxle - Introduction & Repair Instructions › Repair Instructions › Floor Shift Control Replacement › Installation Procedure

Installation Procedure

    Fig 1: Console Shift Control Assembly
    GM161200Courtesy of GENERAL MOTORS CORP.
  1. Install the console shift control into the vehicle.
    2. NOTE: Refer to Fastener Notice .
  2. Install the console shift control retaining nuts.

    Tighten:  Tighten the console shift control retaining nuts to 24 N.m (18 lb ft).

  3. Install the park/lock cable. Refer to Park Lock Cable Replacement .
  4. Install the automatic transaxle range selector cable. Refer to Automatic Transmission Range Selector Cable Replacement .
    5. Fig 2: Removing Console Shift Control Wiring Harness
    GM161196Courtesy of GENERAL MOTORS CORP.
  5. Install the console shift control wiring harness.
  6. Install the console wiring harness.
  7. Install the console trim plate. Refer to Trim Plate Replacement - Console Front or Console Replacement - Front Floor in Instrument Panel, Gages and Console.
About FixVault