FixVault
Home › Buick › 2005 › LeSabre Custom, 4T65E/M15 › Repair and Diagnosis › Engine Performance › System › Engine Controls - Introduction › Repair Instructions › Mass Airflow (MAF) Sensor Replacement › Installation Procedure

Installation Procedure

    Fig 1: Removing/Installing Mass Airflow (MAF) Sensor
    GM378168Courtesy of GENERAL MOTORS CORP.
  1. Install the MAF sensor (1) to the throttle body.
  2. Install the screws (9) that hold the MAF sensor to the throttle body.

    Tighten:  Tighten the screws to 3 N.m (27 lb in).

  3. Connect the MAF sensor electrical connector (8) to the MAF sensor (1).
  4. Install the fuel injection sight shield. Refer to Fuel Injector Sight Shield Replacement (L36) .
About FixVault