FixVault
Home › Buick › 2005 › LeSabre Custom, 4T65E/MN3 › Repair and Diagnosis › Engine Performance › System › Engine Controls - Introduction › Repair Instructions › Intake Air Temperature (IAT) Sensor Replacement › Removal Procedure

Removal Procedure

  1. Turn OFF the ignition switch.
    2. Fig 1: View of Intake Air Temperature Sensor and Electrical Sensors
    GM471749Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the electrical connector (2) from the intake air temperature (IAT) sensor (1).
    3. Fig 2: View of Intake Air Duct
    GM487939Courtesy of GENERAL MOTORS CORP.
  3. Grasp and, with a twisting and pulling motion, remove the IAT sensor from the intake air duct (1).
About FixVault