FixVault
Home › Buick › 2005 › Park Avenue Base › Repair and Diagnosis (Single Page) › Accessories & Equipment › Communication Devices › Computer/Integrating Systems › Repair Instructions › Instrument Panel Module Replacement › Installation Procedure

Installation Procedure

IMPORTANT: After the IPM is replaced, recalibrate the actuators for proper travel. Turn ON the ignition for 3 minutes to recalibrate the IPM and the actuators for proper travel.
  1. Connect the electrical connectors to the IPM.
    2. Fig 1: Removing/Installing Instrument Panel Module
    GM262477Courtesy of GENERAL MOTORS CORP.
  2. Install the IPM (1) into the retainer on the bracket (2).
  3. Close the instrument panel compartment.
  4. Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure (Top Post) in Engine Electrical.
About FixVault