FixVault
Home › Buick › 2005 › Park Avenue Base › Repair and Diagnosis › Engine Performance › System › Engine Control System - Introduction › Repair Instructions › Manifold Absolute Pressure (MAP) Sensor Replacement (VIN 1) › Installation Procedure

Installation Procedure

    Fig 1: Removing/Installing Manifold Absolute Pressure (MAP) Sensor (VIN 1)
    GM12345Courtesy of GENERAL MOTORS CORP.
  1. Connect the electrical connector and vacuum hose to the MAP sensor.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Position the MAP sensor to the bracket and secure with the screws.

    Tighten:  Tighten the screws to 5 N.m (44 lb in).

  3. Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement (L36) or Fuel Injector Sight Shield Replacement (L67) .
About FixVault