FixVault
Home › Buick › 2005 › Park Avenue Base › Repair and Diagnosis › Engine Performance › System › Engine Control System - Introduction › Repair Instructions › Manifold Absolute Pressure (MAP) Sensor Replacement (VIN 1) › Removal Procedure

Removal Procedure

  1. Turn OFF the ignition.
  2. Remove the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement (L36) or Fuel Injector Sight Shield Replacement (L67) .
    3. Fig 1: Removing/Installing Manifold Absolute Pressure (MAP) Sensor (VIN 1)
    GM12345Courtesy of GENERAL MOTORS CORP.
  3. Remove the screws.
  4. Disconnect the MAP sensor electrical connector and vacuum hose from the sensor.
  5. Remove the MAP sensor.
About FixVault