FixVault
Home › Buick › 2006 › Lucerne CXS › Repair and Diagnosis › Engine Performance › System › Engine Controls - 4.6L - DTC P0016 To DTC P0401 › DTC P0107 or P0108 › Circuit/System Verification

Circuit/System Verification

IMPORTANT: The MAP sensor 5-volt reference circuit is spliced to other components of the vehicle.
  1. If DTC P0641 or P0651 are set, refer to Diagnostic Trouble Code (DTC) List - Vehicle .
  2. Verify the integrity of the entire air induction system by inspecting the following conditions:
    • Any damage to or hairline fractures of, the MAP sensor housing
    • Loose or improper MAP sensor installation
    • Any vacuum leak
  3. Verify that restrictions do not exist in the MAP sensor port or vacuum source.
  4. Determine the current vehicle testing altitude.
  5. Ignition ON, observe the scan tool BARO Sensor parameter. Compare the parameter to the Altitude vs Barometric Pressure table. Refer to Altitude Versus Barometric Pressure .
  6. Use the scan tool and compare the MAP Sensor parameter to a known good vehicle under various operating conditions.
  7. Engine running, observe the DTC information with a scan tool. DTCs P0107 or P0108 should not set.
  8. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
About FixVault