Removal Procedure
WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the rear seat cushion. Refer to Rear Seat Cushion Replacement .
- Remove the rear seat back. Refer to Rear Seat Back Replacement (Folding) or Rear Seat Back Replacement (Non-folding) .
- Remove the left rear quarter lower panel. Refer to Rear Quarter Lower Trim Panel Replacement .
- Remove the left rear upper quarter trim panel. Refer to Rear Quarter Upper Trim Panel Replacement .
- Lower the rear of the headliner. Refer to Headlining Trim Panel Replacement .
- Disconnect the antenna cable from the radio antenna module.
- Remove the lower center pillar trim panel. Refer to Center Pillar Lower Trim Panel Replacement .
- Remove the left lower pillar garnish molding. Refer to Lower Pillar Garnish Molding Replacement .
- Adjust the carpet for access to the antenna cable and body harness as required. Refer to Front Floor Panel Carpet Replacement .
- Disconnect the antenna cable from the antenna extension cable.
- Cut off the visible ends of the antenna cable from the wiring harness in the following locations:
- The lower pillar garnish molding
- The rear header area