FixVault
Home › Buick › 2007 › Allure CXS › Repair and Diagnosis › Body & Frame › Windows › Fixed & MOVEABLE Window Systems › Repair Instructions › Front Side Door Window Regulator Replacement › Installation Procedure

Installation Procedure

  1. Install the power window motor to the window regulator. Refer to Front Side Door Window Regulator Motor Replacement .
    2. Fig 1: Window Regulator
    GM1362845Courtesy of GENERAL MOTORS CORP.
  2. Install the window regulator and motor through the access opening in the inner door panel.
  3. Install the nuts (2, 4) to the window regulator studs.
  4. Install the window regulator motor bolts (3).
    5. NOTE: Refer to Fastener Notice .
  5. Tighten the window regulator bolt and nuts to the door.

    Tighten:  Tighten the bolt and nuts to 10 N.m (89 lb in).

    6. Fig 2: Power Window Motor Electrical Connector
    GM1362843Courtesy of GENERAL MOTORS CORP.
  6. Connect the electrical connector to the power window motor and push in on the tab to lock in place.
  7. Remove the masking tape.
  8. Lower the window far enough in order to gain access through the inner panel to the window guide retainer to snap the window into the retainer.
  9. Inspect the window for proper operation.
  10. Install the front door water deflector. Refer to Front Side Door Water Deflector Replacement .
  11. Install the front door trim panel. Refer to Front Side Door Trim Panel Replacement .
About FixVault