FixVault
Home › Buick › 2007 › Lucerne CXS › Repair and Diagnosis › Engine Performance › System › Engine Controls And Fuel - 4.6L - DTC P0016 To DTC P0341 › DTC P0106 › Circuit/System Testing

Circuit/System Testing

  1. Ignition OFF, disconnect the MAP sensor harness connector at the MAP sensor.
  2. Ignition OFF, allow at least 60 seconds for the control module to power down.
  3. Test for less than 5 ohms of resistance between the low reference circuit terminal A and ground.
    • If greater than the specified range, test the low reference circuit for an open/high resistance. If the circuit tests normal, replace the ECM.
  4. Ignition ON, test for 4.8-5.2 volts between the 5-volt reference circuit terminal C and ground.
    • If less than the specified range, test the 5-volt reference circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the ECM.
    • If greater than the specified range, test the 5-volt reference circuit for a short to voltage. If the circuit tests normal, replace the ECM.
  5. Verify the scan tool MAP Sensor parameter is less than 12 kPa.
    • If greater than the specified range, test the signal circuit terminal B for a short to voltage. If the circuit tests normal, replace the ECM.
  6. Install a 3-amp fused jumper wire between the signal circuit terminal B and the 5-volt reference circuit terminal C. Verify the scan tool MAP Sensor parameter is greater than 103 kPa.
    • If less than the specified range, test the signal circuit terminal B for a short to ground or an open/high resistance. If the circuit tests normal, replace the ECM.
  7. If all circuits test normal, test the MAP sensor. Refer to Component Testing below for instructions.
About FixVault