FixVault
Home › Buick › 2007 › Rendezvous CX › Repair and Diagnosis › Body & Frame › Door Locks › Keyless Entry System And Remote Functions › Repair Instructions › Garage Door Opener Replacement › Installation Procedure

Installation Procedure

    Fig 1: Identifying Garage Door Opener & Switch Assembly Retaining Screws
    GM323068Courtesy of GENERAL MOTORS CORP.
  1. Align the LED indicator with the hole in the access panel when setting the opener into place.
  2. Install the opener and the switch assembly to the console.
    3. NOTE: Refer to Fastener Notice .
  3. Install the screws that retain the opener and the switch assembly to the console.

    Tighten:  Tighten the screws to 2 N.m (18 lb in).

    4. Fig 2: Aligning Access Panel
    GM323063Courtesy of GENERAL MOTORS CORP.
  4. Connect the electrical connector to the opener and the switch assembly.
  5. Swing the access panel up and rearward in order to close the access panel.
    6. Fig 3: Pressing Access Panel Barbed Tab
    GM323059Courtesy of GENERAL MOTORS CORP.
  6. Snap the barbed tab into place in the console.
  7. Refer to Control Module References for programming and setup information.
About FixVault