FixVault
Home › Buick › 2008 › Allure CX › Repair and Diagnosis › Engine Performance › System › Engine Control System & Fuel System - 3.8L - Introduction (2 Of 2) › Repair Instructions › Barometric Pressure Sensor Replacement › Removal Procedure

Removal Procedure

    Fig 1: Locating MAP & BARO Sensors
    GM1210599Courtesy of GENERAL MOTORS CORP.
  1. Remove the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement .
  2. Disconnect the barometric pressure (BARO) sensor electrical connector.
  3. Remove the BARO sensor retainer.
  4. Remove the BARO sensor.
About FixVault