FixVault
Home › Buick › 2008 › Allure CXS › Repair and Diagnosis › Restraints › Restraints Control Systems › Seat Belt System › Repair Instructions › Seat Belt Retractor Replacement - Right Front › Installation Procedure

Installation Procedure

    Fig 1: Identifying Seat Belt Retractor
    GM1277004Courtesy of GENERAL MOTORS CORP.
  1. Install the belt retractor into the T-slot in the center pillar.
    2. NOTE: Refer to Fastener Notice .
  2. Install the seat belt retractor bolt.

    Tighten:  Tighten the seat belt retractor bolt to 45 N.m (33 lb ft).

  3. Install the intermediate guide bolts.

    Tighten:  Tighten the intermediate guide bolts to 10 N.m (89 lb in).

  4. Position the guide loop to the guide adjuster bracket.
  5. Install the guide loop nut.

    Tighten:  Tighten the guide loop nut to 42 N.m (31 lb ft).

  6. Install the lower center pillar trim. Refer to Center Pillar Lower Trim Panel Replacement .
  7. Install the upper center pillar trim. Refer to Center Pillar Upper Trim Panel Replacement .
About FixVault