FixVault
Home › Buick › 2009 › Allure CX › Repair and Diagnosis › Engine Performance › System › Data Communication System › Diagnostic Information and Procedures › DTC B1014 › Circuit/System Verification

Circuit/System Verification

  1. Program or configure the module that set DTC B1014. Refer to Control Module References for the specific instructions.
    • If the module will not configure, replace the module that set the DTC.
  2. With a scan tool, clear the DTC.
  3. Ignition OFF, remove the scan tool, open and close the drivers door.
  4. Wait 60 seconds, then recheck for DTCs.
    • If DTC B1014 returns, replace the module.
About FixVault