FixVault
Home › Buick › 2009 › Allure CX › Repair and Diagnosis › Engine Performance › System › Engine Control System & Fuel System - 3.8L - Introduction › Repair Instructions › Fuel Tank Pressure Sensor Replacement (NU6) › Removal Procedure

Removal Procedure

    Fig 1: Identifying fuel tank wiring harness electrical connector
    GM1755107Courtesy of GENERAL MOTORS CORP.
  1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Disconnect the fuel tank wiring harness electrical connector (2) from the fuel tank pressure sensor.
  3. Remove the fuel tank pressure sensor (1).
About FixVault