FixVault
Home › Buick › 2009 › Lucerne Super › Repair and Diagnosis › Engine Performance › System › Engine Controls And Fuel - 4.6L - Introduction › Repair Instructions › Camshaft Position Sensor Replacement › Removal Procedure

Removal Procedure

    Fig 1: Identifying CMP Sensor Wiring Harness Connector
    GM1672927Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the electrical connector (1) from the camshaft position (CMP) sensor.
    2. Fig 2: Identifying CMP Sensor
    GM1672561Courtesy of GENERAL MOTORS CORP.
  2. Remove the CMP sensor bolt.
  3. Remove the CMP sensor.
About FixVault