FixVault
Home › Buick › 2011 › Lucerne Super › Repair and Diagnosis › Engine Performance › Engine Control Systems › Engine Controls And Fuel - 4.6L - Repair Instructions › Repair Instructions › Camshaft Position Sensor Replacement › Installation Procedure

Installation Procedure

    Fig 1: Identifying CMP Sensor
    GM1672561Courtesy of GENERAL MOTORS COMPANY
  1. Lubricate the CMP sensor O-ring seal with clean engine oil.
  2. Install the CMP sensor.
    3. CAUTION:

    Refer to Fastener Caution .

  3. Install the CMP sensor bolt.

    Tighten 

    Tighten the bolt to 10 N.m (89 lb in).

    4. Fig 2: Identifying CMP Sensor Wiring Harness Connector
    GM1672927Courtesy of GENERAL MOTORS COMPANY
  4. Connect the electrical connector (1) to the CMP sensor.
About FixVault