FixVault
Home › Buick › 2011 › Lucerne Super › Repair and Diagnosis › Engine Performance › Engine Control Systems › Engine Controls And Fuel - 4.6L - Repair Instructions › Repair Instructions › Knock Sensor Replacement › Removal Procedure

Removal Procedure

    Fig 1: Identifying Electrical Connector
    GM1672557Courtesy of GENERAL MOTORS COMPANY
  1. Remove the intake manifold. Refer to Intake Manifold Replacement .
  2. Disconnect the electrical connector (3) from the right knock sensor, if required.
    3. Fig 2: Identifying CKP Sensor Wiring Harness Electrical Connector
    GM1672558Courtesy of GENERAL MOTORS COMPANY
  3. Disconnect the electrical connector (2) from the left knock sensor, if required.
    4. Fig 3: Identifying Knock Sensor
    GM1672563Courtesy of GENERAL MOTORS COMPANY
  4. Remove the appropriate knock sensor. Cylinder heads shown removed for clarity.
About FixVault