Circuit/System Description

The secondary air injection system aids in the reduction of hydrocarbon emissions during a cold start. The electric air pump forces fresh air into the exhaust stream in order to accelerate the catalyst operation. A pressure sensor is used to monitor the air flow from the secondary air injection pump. The ECM supplies voltage to the 5-volt reference circuit and supplies a ground to the low reference circuit. The sensor provides a signal voltage to the ECM relative to the pressure changes within the secondary air injection system.

Ignition voltage is supplied to the secondary air injection pump and air injection solenoid valve relays. The ECM controls the relays by grounding the control circuits, which activates the relays. When the relay contacts close, voltage is supplied to the pump and the solenoid valve, which turns the pump on and opens the solenoid valve.

The diagnostic uses 3 phases to test the secondary air injection system:

• DTCs P0411 and P2430 run during Phase 1
• DTCs P2430 and P2440 run during Phase 2
• DTC P2444 runs during Phase 3

During phase 1, both the secondary air injection pump and the secondary air injection solenoid valve are activated. Normal secondary air function occurs. Expected system pressure is 8-15 kPa (1.2-2.2 psi) above BARO.

During phase 2, only the secondary air injection pump is activated. The solenoid valve is closed. Pressure sensor performance and solenoid valve deactivation are tested. Expected system pressure is 15-22 kPa (2.2-3.2 psi) above BARO.

During phase 3, neither the secondary air injection pump nor the secondary air injection solenoid valve is activated. Secondary air injection pump deactivation is tested. Expected system pressure equals BARO.