Sunroof Window Motor Initialization
WARNING: This page is about a different car, the 2011 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.
Perform the Initialization/Teach Process any time the sunroof motor/actuator is removed from the sunroof.
- Ensure that the electrical harness on the headliner is connected to the sunroof motor.
- Re-initialization (Normalization) - Press "Manual Close Switch" for more than 10 seconds, the sunroof's position will not change during the initialization process.
- Make sure the sunroof window is in the full close position before re-initialization.
- Learn:
- Open the sunroof window/sunshade with the express or manual open switch to the full open position then release the switch.
- Press "Manual Open Switch" for more then 10 seconds or until the sunroof window starts AND reaches the Close Position.
- Verify the operation of the sunroof.
NOTE:
The Initialization/Teach Process is not complete if any of the following actions take place before the initialization cycle is done:
The Initialization/Teach Process must be restarted if the procedure is not carried out completely.
- The sunroof switch is not held in the close position.
- The ignition and/or battery power has been removed.
- The glass panel has not reached the closed position.
The Initialization/Teach Process must be restarted if the procedure is not carried out completely.