FixVault
Home › Buick › 2012 › Regal Base › Repair and Diagnosis › External Pages › Different car › Section 30 (SRS (Supplemental Restraint System)) › Front Impact Sensor Replacement › Removal

Front Impact Sensor Replacement: Removal

WARNING: This page is about a different car, the 2011 Honda Insight and 2010 Honda Insight. However, it is still accessible from the selected car via links, so may be relevant.
  1. Do the 12 volt battery terminal disconnection procedure (see 12 VOLT BATTERY TERMINAL DISCONNECTION AND RECONNECTION ), then wait at least 3 minutes before starting work.
  2. Remove the front inner fender (see FRONT INNER FENDER REPLACEMENT ).
  3. Disconnect the engine compartment wire harness 2P connector (A) from the front impact sensor (C).
    Fig 1: Identifying Engine Compartment Wire Harness 2P Connector And TORX Bolt
    G06432317Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Remove the TORX bolt (C) using a TORX T30 bit, then remove the front impact sensor.
About FixVault