Pre-Operation Check Set-up

WARNING: This page is about a different car, the 2011 Honda Insight and 2010 Honda Insight. However, it is still accessible from the selected car via links, so may be relevant.

Before doing the ODS unit operation check, make sure the 12 volt battery is fully charged.
Make sure all the components of the front passenger's seat are correctly installed.
Position the front passenger's seat all the way rearward. Adjust the seat-back all the way forward. Do not move the seat from this position.
Make sure nothing is on or under the front passenger's seat.
Make sure there is nothing in the front passenger's seat-back pocket.
Keep the windows closed.
Do all calibration procedures, except test-driving, in the service bay.
Make sure the vehicle is on level ground.
Turn the heater and the A/C off.
Do not touch the front passenger's seat during the operation check.
Do not expose the front passenger's seat to sudden temperature changes.
Make sure all aftermarket devices such as amplifiers, fluorescent light, air purifiers, CB or HAM radios, etc. are turned off.