SRS Unit Replacement: Installation
WARNING: This page is about a different car, the 2011 Honda Insight and 2010 Honda Insight. However, it is still accessible from the selected car via links, so may be relevant.
- Install the SRS unit (A) with a new TORX bolts (B), then connect the connectors (C) to the SRS unit; push them into position until they click (see WATER PROOF CONNECTORS FOR SRS SYSTEM
).NOTE: Be sure the SRS unit is sitting squarely against its bracket before torquing the TORX bolts.
- Do the 12 volt battery terminal reconnection procedure (see 12 VOLT BATTERY TERMINAL DISCONNECTION AND RECONNECTION ).
- Make sure the SRS unit has the latest software. If it does not have the latest, update the software in the SRS unit (see SRS UNIT UPDATE ).
- Do the front passenger's weight sensor initialization (see FRONT PASSENGER'S WEIGHT SENSOR INITIALIZATION ).
- Do the ODS unit operation check (see ODS UNIT OPERATION CHECK ).
- Confirm proper SRS operation: Turn the ignition switch to ON (II); the SRS indicator should come on for about 6 seconds and then go off.
- Reinstall all removed parts.